Pressure controllers
Boiler controller MOG-1000-O2K
Back
Boiler computer system with O2-Controller
Description
The MOG-1000-O2K boiler computer is developed to optimize heat production for the best economy at your plant, and to supply maintenance personnel with information that will simplify their work.
The MOG-1000-O2K boiler computer is based on a microcontroller and electronic process memories, which makes the MOG-1000-O2K very flexible. The MOG-1000-O2K can be programmed for use with practically any type of boiler, Owen, burner or fuel.
The individual functions and operating parameters are programmed into the computers memory for each boiler using the built-in keypad. Programming can also be done remotely using the MDS-10 or MOS-1000 Operator System HMI interface.
MOG-1000-O2K for biofuel firing:
prepared for use with all types of boilers;
Hot water boilers
Steam boilers
Hot oil-fired boilers
Biomass boilers
MOG-1000-O2K for non-biofuel firing:
prepared for use on all types of boilers;
Hot water boilers
Steam boilers
Oil-fired boilers
Gas-fired boilers
Coal-fired boilers
Natural draught boilers
Induced draught boilers
Forced draught boilers
Positive/Negative pressure furnace
Functions
Temperature or steam pressure control:
Control functions for start and stop of burners
On/Off controller for speed flue gas fan
On/Off controller for combustion air fans and fuel supply
Power controller (3-point PI controller) for modulating burners
Sequel control of set points for On/Off controller and Power controller
Control of negative pressure in the furnace or control of combusted air:
Evacuation of gases at burner stop
Manual/Auto switch
Downtime pressure for biomass fired boilers
Sweeping position
O2-Control:
O2-controller with a programmable set point curve
Alarms:
Alarm functions for sequential control of boilers and remote indication
Communication:
Data communication with computer
Monitoring with limits for warning and stop:
Monitoring of the pressure in the furnace or the differential pressure
Monitoring of the flue gas temperature
Monitoring of the O2-content in the flue gases
Monitoring of combustion efficiency
Monitoring of oil and gas consumption
Monitoring of optional temperature (for example combusted air or oil). This temperature may also be controlled if the power control is not used
Monitoring of mA signals
Switches:
Fan guard (for induced draught boilers)
Pressure switch, positive or differential, separate from the MOG-1000-O2K
Relevant documents
Back
